280
which may require alternate routing of calls to another PSAP.
When the PSAP reports this condition on all screens but not all calls and has voice contact with callers, the report should be referred to SSIM/I&M for dispatch. The SSC/MAC should verify with the SCC that ANI is pulsing before dispatching SSIM.
When the PSAP reports this condition on one screen for all calls (others work fine) the trouble should be referred to SSIM/I&M for dispatch, because the trouble is isolated to one piece of equipment at the customer premise.
An ANI failure (i.e. all zeroes) indicates that the ANI has not been received by the PSAP from the tandem office or was lost by the PSAP ANI controller. The PSAP may receive "02" alarms which can be caused by the ANI controller logging more than three all zero failures on the same trunk. The PSAP has been instructed to report this condition to the SSC/MAC since it could indicate an equipment trouble at the PSAP which might be affecting all subscribers calling into the PSAP. When all zeroes are being received on all calls or "02" alarms continue, a tester should analyze the condition to determine the appropriate action to be taken. The tester must perform cooperative testing with the SCC when there appears to be a problem on the Tandem-PSAP trunks before requesting dispatch.
When an occasional all zero condition is reported, the SSC/MAC should dispatch SSIM/I&M to routine equipment on a "chronic" troublesweep.
The PSAPs are instructed to report incidental ANI failures to the BOC on a PSAP inquiry trouble ticket (paper) that is sent to the Customer Services E911 group and forwarded to E911 center when required. This usually involves only a particular telephone number and is not a condition that would require a report to the SSC/MAC. Multiple ANI failures which our from the same end office (XX denotes end office), indicate a hard trouble condition may exist in the end office or end office tandem trunks. The PSAP will report this type of condition t
