Things To Make

Things To Make

By

5
(1 Review)
Things To Make by Archibald Williams

Published:

1900

Pages:

188

Downloads:

3,825

Share This

Things To Make

By

5
(1 Review)

Book Excerpt

shoulders. Its fellow on the other side of the legs is prepared in exactly the same manner; and the second trestle is a duplicate of the first, with the exception that the directions of the struts are reversed relatively to the C piece, to preserve the symmetry--which, however, is not an important point.

[Illustration: FIG. 5.--End elevation of joiner's bench.]

Back and Front.--The only operation to be performed on the front piece B and the back G is the notching of them both on the inside faces at the centre to take the ends of the bearer F, which performs the important function of preventing any bending of the top planks. Lay the boards together, top edges and ends level, and mark them at the same time. The square is then used on the faces to give the limits for the notches, which should be 1/4 inch deep and chiselled out carefully.

Draw cross lines with your square 3 inches from each end of both pieces, on the inside, to show where the legs are to be. Bore holes in the boards for the

Readers reviews

5
4
3
2
1
5.0
Average from 1 Review
5
Write Review
Matthew s. Cox - Creating Science Fiction and Fantasy Worlds
FEATURED AUTHOR - Originally from South Amboy NJ, Matthew has been creating science fiction and fantasy worlds for most of his reasoning life. Since 1996, he has developed the "Divergent Fates" world in which Division Zero, Virtual Immortality, The Awakened Series, The Harmony Paradox, the Prophet of the Badlands series, and the Daughter of Mars series take place. His books span adult, young-adult, and middle-grade fiction in multiple genres, predominantly science fiction, cyberpunk, post-apocalyptic, and… Read more